Research progress and hot spots of hydrothermal liquefaction for bio-oil production based on bibliometric analysis

Environmental Science and Pollution Research - Hydrothermal liquefaction (HTL) of biomass used HTL reaction under high temperature and pressure to produce bio-oil. This technology is considered as...     

Protective effects of dietary betaine on intestinal barrier function and cecal microbial community in indigenous broiler chickens exposed to high temperature environment

Environmental Science and Pollution Research - High temperature environment causes reduction in productivity in broilers by disrupting the intestinal barrier function. This study aimed to...     

Uptake and concentration of heavy metals in dominant mangrove species from Hainan Island,South China

Environmental Geochemistry and Health - By investigating three dominant mangrove species, namely Aegiceras corniculatum, Kandelia candel, Ceriops tagal and their rhizosediment in Mangrove wetlands...     

Control of NOx emissions by air staging in small- and medium-scale biomass pellet boilers

Environmental Science and Pollution Research - The effect of air staging strategies on NOx control was investigated on a 210-kW small-scale biomass boiler (SBB) and a 1.4-MW medium-scale biomass...     

Structural and technological determinants of carbon intensity reduction of China’s electricity generation

Environmental Science and Pollution Research - Electricity generation is the largest sector with decarbonization potential for China and the world. Based on the new emission factors, this paper...     

Comparison on surface properties and desulfurization of MnO2 and pyrolusite blended activated carbon by steam activation

In this study, MnO₂ and pyrolusite were used as the catalysts to prepare modified activated carbon, that is, AC-Mn and AC-P, respectively, from coals by blending method and steam activation. The Brunauer–Emmett–Teller (BET) results indicated that the AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The relative contents of basic functional groups (i.e., C = O, π-π*) on AC-P were slightly lower than those on AC-Mn, while both contained the same main metal species, namely, MnO. The desulfurization results showed that with 3 wt% of blending ratio, AC-Mn3 and AC-P3 had higher sulfur capacities at 220 and 205 mg/g, respectively, which were much higher than for the blank one (149.6 mg/g). Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn, which might be attributed to the existence of other metals in pyrolusite. After the desulfurization process, MnO were gradually transferred into MnSO₄, and the relative contents of basic functional groups decreased evidently for both AC-Mn3 and AC-P3. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurization.

Implications: MnO₂ and pyrolusite were used as the additives to prepare modified activated carbon from coals by a blending method and by steam activation, that is, AC-Mn and AC-P, respectively. The AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The AC-Mn and AC-P had higher sulfur capacities than a blank one. Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurizatio.     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

萃取法分离回收不锈钢酸洗污泥硫酸浸出液中的重金属

采用非皂化P204和皂化P204萃取剂对不锈钢酸洗污泥的硫酸浸出液进行萃取。在浸出液pH为0.80、非皂化P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取时间为5 min的条件下,Fe~(3+)萃取率达99.64%,Cr~(3+)和Ni~(2+)萃取率为3.98%和6.99%,一次萃余液pH为0.64。采用皂化P204对除Fe~(3+)后的一次萃余液进行萃取,在P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取剂皂化率为60%、一次萃余液pH为1.50、萃取时间为5 min的条件下,Ni~(2+)萃取率为93.12%,Cr~(3+)萃取率为20.69%,二次萃余液pH为2.63。     

磁性Fe_3O_4/石墨烯纳米复合材料催化降解水中17β-雌二醇

利用化学沉淀法制备磁性四氧化三铁/石墨烯(Fe3O4/GE)纳米复合材料,并将其与H2O2构成非均相Fenton体系用于催化降解水中微量的17β-雌二醇(E2),研究了初始p H值,初始H2O2浓度,催化剂用量对E2降解的影响。结果表明,Fe3O4/GE纳米复合材料在无需外加光源的条件下能够有效催化降解E2。在p H 7.0,E2初始浓度为1 mg/L,初始H2O2浓度为15 mmol/L,Fe3O4/GE投加量为15 mg/L的条件下,反应8 h后可去除92.9%的E2。Fe3O4/GE具有便捷的磁分离特性和稳定的催化活性,经过7次循环使用后对E2的降解效率仍保持在91.5%左右。     

EGSB出水回流对EGSB—SBR工艺处理果汁废水的影响

采用EGSB—SBR工艺处理实际果汁废水(COD 2 608~6 500 mg/L,p H 5.0~7.0)。在EGSB反应器成功启动及驯化完成的情况下,连续运行49 d。实验结果表明:第25天起,控制EGSB回流比为3.00∶1,EGSB反应器可在无须添加Na HCO3的条件下稳定运行,从而降低了废水处理成本;第25天起,平均进水COD,BOD5,SS分别为5 968,2 130,1 020 mg/L,平均出水COD,BOD5,SS分别降至131,11,50 mg/L,平均COD,BOD5,SS去除率分别为98%,99%,95%;组合工艺对该实际果汁废水具有良好的处理效果。